2017-2021 Duramax 6.6L L5P 5" Downpipe-Back Dual Exhaust Installation Guide
Source: https://www.spelabautoparts.com/pages/2017-2021-duramax-6-6l-l5p-5in-downpipe-back-dual-installation-guide
You can also download the original PDF of these installation instructions: 5" Downpipe-Back Dual Installation Instructions (PDF) . Warning Warning: This system is designed for race use only. May also void vehicle manufacturer's warranty. Allow the truck's exhaust system to cool before removal. Always practice safe work habits, i.e. jack stands, gloves, safety glasses etc. Notes: Performance Exhaust Systems are designed to fit stock trucks with OEM hitches, tires, wheels, and spare sizes. Any suspension lifts or other variations may require modification of the new exhaust system for proper fit and finish. Place clamps on connections before installing pipes. Do not tighten clamps until the complete system is in place. Snug clamp down so it will hold the pipe but pipe can still be moved. WD40 or equal will make removal of hangers easier. A small tack with a mig welder is recommended on all clamp connections. Installation Notes Note: Prior to installation, please compare the parts that you have received with the bill of materials listed above to ensure that you have all the necessary parts for installation. Installation Steps Step 1: Starting at the bottom of the turbo direct pipe, remove the 4 fasteners from the turbo direct pipe. Step 2: Starting at the bottom of the turbo direct pipe, remove the 4 fasteners from the turbo direct pipe. Step 3: Install pipe #11711 using factory hardware. Place hanger in stock location and snug the 4 fasteners so it will hold pipe but pipe can still be moved with some effort. Step 4: Install pipe #11252 on end of pipe #11711 and fitting hanger into stock location. Step 5: Install pipe #50012 and/or #50018. CH54 hanger will only be used on long wheelbase models where rubber isolator is present (note: some trimming of extension pieces MAY be required depending on wheelbase.) (Note: be sure to allow for tubing connections approx. 5" also making sure to cut from the non-expanded end of pipe). Step 6: Install Y-pipe (Y500) onto the end of the pipe in step 5. Step 7: Install driver's over the axle pipe #11764 into driver's outlet of Y-pipe and hang in the stock rubber hanger located above. Step 8: Install H1 hanger into the hole in the frame located directly behind the driver's side upper shock mount using the bottom hole on the hanger. (note: ensure the metal of the hanger is on the inside of the frame with the rubber facing towards the outside of the truck) See Fig1 Step 9: Install driver's tailpipe #11765 onto #11764 and into the H1 hanger. Install passenger over the axle pipe #11762 into the passenger outlet of the Y-pipe. Install passenger tailpipe #11763 onto pipe #11762 using the factory hanger location. Check for clearances, i.e. brake lines may have to be moved, or e-brake cables as well as axle vent tube, also check to make sure that the exit of tail pipes are level with truck. Starting at pipe #11711, fully tighten the 4 fasteners at the turbo direct pipe. Starting at the front clamp work your way to the back connection on right side of truck. Now tighten the left side of the truck Note: a mig weld should be applied to clamp connections for added security. DO NOT WELD CLAMPS. Technical Support Technical Support: email us service@spelabautoparts.com www.spelabautoparts.com Phone: +1 888 301 8666 Mon - Fri: 9:00 AM - 6:00 PM EST Sat - Sun: Closed