2013-2026 Dodge Ram 2500 3500 6.7L Cummins DPF Back Exhaust Installation Guide
Source: https://www.spelabautoparts.com/pages/2013-2026-dodge-ram-2500-3500-6-7-cummins-dpf-back-exhaust-installation-guide
This installation instructions apply to Dodge Ram 2500 and Ram 3500 trucks with the 6.7L Cummins diesel engine: 2013-2018 Ram 2500/3500 — all cab and bed combinations except the Crew Cab Short Box. 2019 and newer Ram 2500/3500 — all 6.7L Cummins configurations. The same 11 steps cover both year groups. Before removing anything from the truck, confirm that the system in the box matches your vehicle's year, model and configuration, and note that this installation is not recommended for trucks equipped with air suspension. 5'' DPF Back for 2013-2025 Dodge Ram 6.7L Diesel Installation Packing Include 1* OVER AXLE PIPE 1* TAIL PIPE 1* 4" CLAMP 1* 5" CLAMP 1* EXHAUST TIP Note While we have made every effort to ensure that all components of this system are of superior quality and properly packaged, it is the installer's responsibility to ensure the following before removal of the factory exhaust: that ALL components shown above are present. that ALL mating components fit together. that there are no damaged components. that the system you have purchased is appropriate for your vehicle year, model and configuration. that the system will not interfere with any modifications previously installed or planned. that you have read and understand these instructions. If you have any questions or are uncertain about any aspect of the installation of this system to your vehicle please contact us before commencing installation. NOT RECOMMENDED FOR VEHICLES EQUIPPED WITH AIR SUSPENSION Installation Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. Lower the spare tire and remove the spare tire heat shield (4 bolts). Loosen the nut on the clamp on the factory tailpipe. Remove the tail pipe from the extension pipe and then from the factory rubber insulator. Remove the stock tail pipe from the vehicle. Slide the 4" Clamp onto the outlet end of the extension pipe. Install the 5" Over Axle Pipe from the rear of the truck, over the axle and install into the factory rubber insulator. On some trucks it may be easier to remove the rubber insulator, then reinstall once the 5" Over Axle Pipe is in place. Install the 5" Tail Pipe onto the extension pipe, taking care to align the tab on the filter to the slot in the 5" Tail Pipe. Slide the 5" Clamp onto the end of the over axle pipe. Install the Tail Pipe onto the Over Axle Pipe. Re-install the spare tire heat shield and raise the spare tire into position. Align the exhaust as required. Starting at the front of the exhaust, tighten all clamps and connections. Install and adjust the Exhaust Tip to suit. Tighten the lock bolt located on Exhaust Tip. Tighten all hardware and clamps, starting at the front and working rearward to secure the system. Check along the full length of the exhaust system to ensure there is adequate clearance for fuel lines, vent lines, brake lines, frame, bodywork, suspension, and any wiring, etc. If there is any interference detected, relocate, or adjust to provide adequate clearance. Ensure all clamp connections are secure and components are unable to rotate or slide. Band clamps require approximately 45 lb-ft (60 N-m) of torque. Verify clearances, system security and band clamp torque after 30-60 miles (50-100 km) of driving. Technical Support Technical Support: email us service@spelabautoparts.com www.spelabautoparts.com Phone: +1 888 301 8666 Mon - Fri: 9:00 AM - 6:00 PM EST Sat - Sun: Closed